TMeter :: Example 1

Example 1

Goal
Monitoring the outgoing and incoming traffic of my computer.

Solution
Let's create a filter to count both the outgoing and incoming traffic. This filter will consist of only one rule.

Filter 1. Traffic from My computer to any host.
N Rule	Type of IP protocol	Source address	Source port	Destination address	Destination port	Both directions	Action for packet	Additional condition
1	Any	My computer		Any		Yes	Count

Note

This filter is the simplest way to check TMeter for the traffic capture
An error will occur, if you use "My Computer" as the source address and "My Computer" as the destination address simultaneously
An error will occur, if you use "Any IP address" as the source address and "My computer" as the destination address simultaneously